REV'IT! Lombard 3 RF Closeout Jeans (Waist 28 Through 31 Only)

We measured a sampling of these jeans of different waist sizes and lengths and find they are much like other jeans you’d buy these days. They are just a bit “vanity” sized in the waist and pretty true in the length. Across the size run, the actual measured waist was just a bit larger than the stated waist size (about 1” in the smaller sizes and about 2” in the bigger sizes which is typical vanity sizing). And of course, these are denim and may shrink just a tad too. The jeans have SeeSmart hip protectors installed. The hip armor is quite thin and flexible so I don’t think they’ll make a difference in the size choice of jeans if you choose to wear them. So my overall advice would be to buy the waist size you normally wear in jeans; you’ll likely find a fit. If you aren’t sure whether your jeans are vanity sized like I’m describing, then either measure your waist where your normal jeans ride or measure your favorite pair of jeans to verify. You’ll probably find that you measure out a bit bigger than your normal jeans size and also the waist of your favorite jeans measures out an inch or two bigger than their stated size. If so, you will be on track following my advice.

The inseam lengths measured out about right as compared to the stated size, BUT there are a couple of considerations here… first, these jeans come standard with knee armor and the knees are reinforced with a layer of an abrasion resistant material. Those two features add a bit of thickness and when you sit, that means the inseam gets a bit shorter than you might expect. You’ll also want to decide if you want to roll your jeans up at the cuff or not. Many people do, so add some inseam if you want to do that. Also, there is a reflective strip on the inside seam at the bottom that only shows when the ends are rolled. So with those considerations in mind I’d recommend you buy one size longer than you normally wear. If between sizes, choose the longer.

Need help measuring? Get it here.

The REV’IT! Lombard 3 RF jeans are a regular fit riding jean that will pair well with just about any jacket for urban and commuter riders.

The Lombard 3 RF jeans are made from a 15 oz. Cordura® denim that offers quite a bit of 4-way stretch. The RF = regular fit style of this pant means the stretch isn’t really necessary, but it is a nice extra level of comfort. The pants taper just slightly as you go down the leg but they are essentially straight leg jeans. Externally the jeans have the appearance of a typical designer jean with two hand pockets and two hip pockets and one well hidden fifth pocket in the right hand pocket for change or keys (trust us, it’s there! It is between two vertical seams and just splits open with no noticeable entry. There is nothing to give away the protection that lies beneath.

The protection in the jeans comes from that Cordura® denim with safety seams that provide good abrasion resistance for slides. The pants also use REV’IT!’s ultra thin and flexible SEESMART™ RV36-L1-A CE level 1 armor on knee and the SEESMART™ RV33 CE-level 1 armor at the hip. At the cuff, there is a reflective strip on the interior of each leg that is visible if you turn the cuff up and provides a bright reflection to other motorists. The jeans also have belt loops so you can easily integrate the REV’IT! Safeway belts (see related products below) for pairing with your favorite REV’IT! riding jacket. These jeans also have a mesh comfort liner through the rise of the jeans to promote airflow between the jeans and your body.

The REV’IT! Lombard 3 RF jeans are a good choice for urban and commuter riders that are looking for a protective jean that they can wear comfortably all day. Just remember they are slightly vanity sized and size appropriately! :: Mike, 08/15/2022